Areas of Use                                                                                                                                                                                        - Indoor and outdoor spaces,
- Horizontal and vertical surfaces,
- Foundations and shear walls,
- Wet spaces, retaining walls,
- Protection and isolation of constructions and construction elements subject to infiltration water, permanent or temporary water pressure,
- Adhesion of isolation and drainage plates. Since it is not UV-resistant, the agent should be properly covered after application.

Advantages
- Easy to apply.
- Solvent-free.
- Ensures joint-free, waterproof coating.
- Adheres well to surfaces thanks to high adherence.
- Ensures crack bridging.
- Applied cold, dries rapidly.
- Does not sag in vertical places.

Surface Preparation
- Surface should be freed from residues that prevent adhesion, such as dust, oil, dirt, paint, curing material and bitumen.
- Damaged sections of concrete, surface fractures and static cracks should be repaired with Lotti Non-Shrinking Fluid Grout Mortar.
- Water holes should be blocked with NEROFLEX SHOCK; fill dynamic crack with NEROFLEX HYBRID or GOOP sealant.
- Apply chamfering on sharp corners and joints of construction elements.
- Apply solvent-free bitumen primer on the surface and proceed to application once the primer is completely dry.

Lining
- Apply lining by diluting the product in 1/5 ratio.
- Apply by spreading the agent in even manner with appropriate brush; do not allow material accumulation on horizontal surfaces.
- Wait for primer to dry before proceeding to actual application.
- Recommended ratio for use: 0.25 kg/m².

Application Information
- Apply on prepared surface in minimum 2 coats with brush, trowel or spray.
- After first coat, wait it to dry completely before proceeding to the second.
- Second coat is applied in perpendicular manner to the first.
- Recommended to use waterproofing mesh between layers in order to improve carrying capacity of product.
Areas of Use
- Do not close foundation pit until through-drying occurs. Apply filling after the coating is preserved with appropriate heat insulation and drainage plates.
- Clean the tools with water before they dry. Solvent may be used to clean dried tools.

Applications Conditions
- Avoid application in temperatures below +5°C and above+30°C.
- Avoid application during rain or when rain is expected.
- Area of application should be protected from effects of wind and direct sunlight during application. Avoid application in areas with risk of frost within 24 hours, or exposed to direct sunlight and wind.
- Application should be made on the construction side that is in contact with water.
- In cold weather, it will take longer for the agent to cure; make sure the first coat has completely dried before proceeding to second coat.
- The indicated consumption amount is for informative purposes only. It may vary depending on application conditions and surface characteristics.

Consumption                                                                                                                                                                                      Total consumption for 2 coats of application is provided in the table below.

* Recommended to use glass fibre reinforcement between layers

Shelf Life                                                                                                                                                                                          12 months as of production date in cool, dry and damp-free spaces of +5°C to +25°C, on wooden pallets, without unpacking.
Do not pile up pallets during storage.
Package     30 kg plastic bucket