Places of Usage
• It is used as waterproofing material under ceramics in all buildings, especially in wet places such as balconies, terraces, bathrooms, toilets and kitchens.

Features/ Advantages
• Ready to use.
• Is applied with brush and roller.
• Maintains elasticity even at low temperatures.
• Provides high adherence.
• Easy and fast to apply.

Application Directions
a) Surface Preparation:
The application surface must be solid, dry, carrier, dust-free and clean and at the same time in balance. The surface should be thoroughly cleaned of any oil, grease, rust and paraffin residues that may weaken the adherence and there should be no loose particles on the surface. Appropriate Neroflex Repair Mortars should be used on unlevel surfaces. New plastered and reinforced concrete surfaces should be waited to complete the curing period of 28 days. Corners and edges should be chamfered with a 4 cm diameter with Neroflex Sealant Mortar or Neroflex Structural Repair Mortar. Surface gaps can be repaired with Neroflex Sealant Mortar or Neroflex Structural Repair Mortar. The flow of water towards the outlet must be ensured. Deep cracks should be filled with joint sealant.
b) Product Preparation:
N3004 Proliquid is a ready - to - use material. In the primer application, 50% water is added to 3004 Proliquidand mixed with 400-600 rpm mixer for 3-5 minutes. First coat and second coat should be applied without mixing with water.
c) Application Method:
The prepared primer should be applied to the surface with a brush or roller (200 gr/m2). After the primer has dried, the other coats should be applied to form a wet film thickness of 1 -1,50mm. Cracks, joints, corners and edges should be supported with the appropriate waterproofing net after the first coat application.

Issues to be Considered
• N3004Proliquid is not suitable for water tank, swimming pool and foundation insulation.
• If the ambient and surface temperature to be applied is below +5° C or above + 30° C, suitable temperatures should be waited.
• The applied material must be protected from rain and frost for the first 24 hours.
• In applications, each layer thickness should not exceed 1-1,50 mm.
• 3004 Proliquidapplied at + 23° C gains sufficient mechanical strength after 5 days.
• After 7 days it becomes waterproof. It reaches its final strength after 14 days. At low temperatures these times are prolonged.
• Precautions should be taken on surfaces that need to be walked on. Reinforce with appropriate net.
• Do not apply on wet and damp surfaces.
• Attention should be paid to the drying time between the coats.

Cleaning of Tools:
Tools and equipment used should be cleaned with water after the application. 3004 Proliquidcan only be removed mechanically from the surface after hardening.

Security Warnings
• S2 Keep out of the reach of children.
• S24/25 Avoid contact with eyes and skin.
• S26 In contact with eye, wash with water and consult a doctor.
• S28 In contact with skin, wash immediately with plenty of water.
• S29 Do not empty into drains.
• S46 If swallowed, consult a doctor immediately and show box or label.
Storage
It should be stored in unopened original package in a cool and dry environment by protecting from frost. For short-term storage, maximum 3 pallets should be placed over and over and the shipment should be made with first in first out system. For long-term storage, pallets should not be placed over and over. It can be stored for 12 months from the date of production if proper storage conditions are met. Opened packages should be kept tightly closed and stored under proper storage conditions and should be used within one week.

Consumption
See the consumption table.

Package
In 20 kg and 3,5 kg plastic buckets.
N3004 Proliquid
Quality Certificates:
Manufactured according to TS EN 1 504-2